Updated CHANGELOG

CHANGELOG.md

@@ -4,6 +4,9 @@ All notable changes to Bambuddy will be documented in this file.
 
 ## [1.2.6b1] - Unreleased
 
+### Added
+- **The K value is on the AMS slot itself, not only in the popover (#2532, requested and contributed by @gyrene2083)** — Reading back a slot's pressure-advance value meant hovering it: the K factor lived in the filament popover alone, so checking whether a calibration had actually taken across four slots was four hovers, and comparing two of them side by side was not possible at all. Every slot card now carries the value under the material name, the way Bambu Studio shows it per slot — on regular AMS units, on AMS-HT, and on the external spool of a dual-nozzle machine. Only a value the printer actually reported is shown: a loaded but never-calibrated slot stays blank rather than inheriting the 0.020 that fills the popover's own field, and a slot the firmware reports as exactly 0 counts as uncalibrated the same way the stored K-profiles do. The label is shortened to **K** with the full localized name on hover, because "K Factor", "K-Faktor" and "Facteur K" ate the value itself — the whole point of the line — on cards under about 350px, and the figure is set in tabular numerals so it measures the same in Safari as in Chromium. Where one slot of a unit is calibrated and its neighbours are not, the neighbours hold the same row open so the fill bars stay level across the card.
+
 ### Fixed
 - **An AMS slot could name the wrong white** — A hex is not one colour in Bambu's range: `#FFFFFF` is Jade White in PLA Basic, Ivory White in PLA Matte and plain White in six other materials, and `#000000` is Charcoal in PLA Matte where it is Black everywhere else. The slot popover looked the colour up by hex alone, and the lookup table can only keep one name per hex — so an ivory Matte spool was titled "Jade White" even while the profile line beside it correctly read Matte Ivory. The colour map now also carries the names that collapsing loses, keyed by material, and every slot resolves its colour with the material the printer reports for it (`tray_sub_brands`). Slots with a spool assigned from Inventory are titled with that spool's own colour name, which is the roll the user actually put in. Only a name the same brand's own range lost is carried — one manufacturer's name must not displace another's — so the added map is 11 entries against the 608 in the shipped catalog.
 - **A queued job switched on printers that could never have printed it** — When no printer of the target model was available, the queue powered one on via its smart plug, but chose it on model alone: it walked the farm in printer-ID order, woke the first machine with an Auto On plug, and only then discovered the loaded filament was the wrong colour. A job for a colour loaded at the far end of the farm therefore woke every earlier printer in turn and left each one running until its own auto-power-off timer expired. The colours were known the whole time — a printer keeps its last reported AMS and external-spool trays after the power goes — so the wake step now asks the same three questions the matcher asks a live printer (required types, forced colours, preferred colours) and passes over a printer whose last known filament cannot satisfy the job. A printer Bambuddy has never heard from is still woken: no reading is not the same as no filament. Reconnecting a printer also no longer discards that reading, so a power-on attempt that times out stops erasing what the next attempt needs.