Momentum-Apps

Flipper Zero Ethernet Troubleshooter

This is a small helper that lets you connect your Flipper via RJ45 to your network You can then set the interface-mac and test if you can get an IP via DHCP and the ping addresses.

Prerequisites

To get started you will need a specific module called the W5500 Lite with a chiop from WHIZnet Co., Ltd. You can find those modules on AliExpress etc. Find Module here The second thing you will need is a proto-board for the Flipper Zero, which you can get here.

Assembly

Connect pins from module to flipper using this scheme:

W5500 Module -> Flipper GPIO

MOSI (MO) -> A7 - 2pin SCLK (SCK) -> B3 - 5pin nSS (CS) -> A4 - 4pin MISO (MI) -> A6 - 3pin RESET (RST) -> C3 - 7pin 3v3 (VCC) -> 3V3 - 9pin GND (G) -> GND - 8pin or 11pin

Original App author: @karasevia - https://github.com/karasevia/finik_eth Improved and updated by: @arag0re & @xMasterX