README.md 904 B
#Simple timelapse/intervalometer app for Flipper Zero, works via GPIO pins.
Control:
- Up and down - time.
- Left and right - number of frames
- Long press arrows - ±10 frames/seconds
- OK - start/pause
- Long press OK - turn on/off the backlight
- Back - reset
- Long press back - exit
1 frame - simple timer, 0 frames - infinite mode, -1 frames - BULB mode
When the timer is running, all buttons are blocked except OK.
What you need:
- two EL817C optocouplers
- pin header connector 1x3 2,54mm male
- some wire
- heat shrink
camera remote connector
How to assemble
Take optocouplers, connect according to the scheme.
Camera pinout can be found here: https://www.doc-diy.net/photo/remote_pinout/