Copy the
following apps to your Flipper (i.e. to
apps/GPIO using
qFlipper) using the version that correspond to your firmware (or
compiling your own version):
- ESP32CAM_Marauder.fap
- ESP32CAM_Camera.fap
- ESP32CAM_Motion.fap
- ESP32CAM_QRcode.fap
Next, while holding pin
IO0 connected to
GND, press reset on the ESP32CAM and upload the firmware pressing Install. For more details on the apps check
this video, or take a look of the
documentation.
Note 1: If you are using your Flipper to upload the firmware, remember to go to GPIO/USB-UART Bridge. After the upload, reset the ESP32 (or unplug/replug the module).
Note 2: If you do not see the Install button below, your browser might not support this functionality.
Enjoy!