Copy the following apps (
compiled for
unleashed) to your Flipper (i.e. to
apps/GPIO using
qFlipper):
Next, while holding pin
IO0 connected to
GND, press reset on the ESP32CAM and upload the firmware pressing Install. For more details on the apps check
this video, or take a look of the
documentation.
Note 1: If you are using your Flipper to upload the firmware, remember to go to GPIO/USB-UART Bridge. After the upload, reset the ESP32 (or unplug/replug the module).
Note 2: If you do not see the Install button below, your browser might not support this functionality.
Enjoy!