|
|
@@ -11,7 +11,7 @@ Following steps are performed in order to re-program target's memory:
|
|
|
|
|
|
1. Peripherals are initialized (GPIO for BOOT and EN pins and UART).
|
|
|
2. UART1 (can be changed) through which new binary will be transfered is initialized.
|
|
|
-3. Host puts slave device into boot mode tries to connect by calling `esp_loader_connect()`.
|
|
|
+3. Host puts target device into boot mode tries to connect by calling `esp_loader_connect()`.
|
|
|
4. Binary file is opened and its size is acquired, as it has to be known before flashing.
|
|
|
5. Then `esp_loader_flash_start()` is called to enter flashing mode and erase amount of memory to be flashed.
|
|
|
6. `esp_loader_flash_write()` function is called repeatedly until the whole binary image is transfered.
|
|
|
@@ -40,9 +40,11 @@ Table below shows connection between the two devices:
|
|
|
|
|
|
## Build and flash
|
|
|
|
|
|
-To run the example, type the following command:
|
|
|
+To run the example, type the following commands:
|
|
|
|
|
|
```c
|
|
|
+west init
|
|
|
+west update
|
|
|
west build -p -b <supported board>
|
|
|
west flash
|
|
|
west espressif monitor
|
Djordje Nedic