|
|
@@ -43,7 +43,7 @@ Requires an ESP32-CAM module (I've personally used these: [Amazon Link 1][amazon
|
|
|
|
|
|
## Hardware Installation <a name="hardware-installation"></a>
|
|
|
|
|
|
-Below is the pinout guide and digram for the ESP32-CAM module to the Flipper Zero. From the ESP32-CAM module to the Flipper Zero:
|
|
|
+Below is the pinout guide and diagram for the ESP32-CAM module to the Flipper Zero. From the ESP32-CAM module to the Flipper Zero:
|
|
|
|
|
|
```
|
|
|
VCC to 3V3
|
|
|
@@ -62,7 +62,7 @@ On the ESP32-CAM module itself you'll also need to connect the `IO0` pin to `GND
|
|
|
|
|
|
1. Download and install the Arduino IDE from [here][arduino-ide].
|
|
|
2. Go to the [releases section][flipper-zero-camera-suite-releases] for this repo and download the `esp32_cam_uart_stream.zip` file.
|
|
|
-3. Extract contents of `esp32_cam_uart_stream.zip` to disk. Be sure to keep the `.ino` file nested in the folder with the same name.
|
|
|
+3. Extract the contents of `esp32_cam_uart_stream.zip` to disk. Be sure to keep the `.ino` file nested in the folder with the same name.
|
|
|
4. Open `~\esp32_cam_uart_stream\esp32_cam_uart_stream.ino` with your Arduino IDE.
|
|
|
5. In the Arduino IDE, go to `File > Preferences`.
|
|
|
6. In the `Settings` tab, add the following URL to the `Additional Boards Manager URLs` field:
|
Cody Tolene