# ESP32CAMMarauder installer

> @erwinried #flipper #flipperzero #esp32 ? original sound - Erwin Ried

Copy the following apps to your Flipper (i.e. to apps/GPIO using qFlipper):

- ESP32CAM_Marauder.fap
- ESP32CAM_Camera.fap
- ESP32CAM_QRcode.fap

Next, while holding pin IO0 connected to GND, press reset on the ESP32CAM and upload the firmware pressing Install.
Note 1: If you are using your Flipper to upload the firmware, remember to go to GPIO/USB-UART Bridge.
Note 2: If you do not see the Install button below, your browser might not support this functionality.

Enjoy!